i am building a deck, have installed all of he sub fream and joists, and now simply need to fasten the deck boards on. if i pre-drill and countersink the screw holes, should i drive the screw below the surface of the board and back fill with something, or should i leave them flush with the surface? thanks mat
unfortunately over time, then tend to come loose. screws are a much better option. but what's done is done but any kind of wood filler is never going to match the deck. with high-end wood decks that are face screwed, they use a special combination drill bit and countersink and then drive wood plugs to cover the screw holes.
re: filling old screw holes in a fiberglass boat. thanks guys. marine-tex it is. my boat is white below the water line, and gray with silver fleck above. i was think about using the white colored marine tex for the white parts, and the gray marine-tex for anything above water.
the joists under the decking are still in relatively good shape so im planning to reuse them. the problem i have is that after removing the deck boards i am left with a bunch of screw holes in the joists. im worried that water will collect in these holes and accelerate the deterioration of the wood.
what's an easy to use filler for old screws holes and something that will fix the splits in my deck joists? i'm replacing some of the 2x6's that have warped and i'd like to repair the joists that have splits and stripped out screw holes from the 2x6s warping.
looking for some ideas on how to fill screw holes in cedar decking. one of my guys doing the fastening of the deck thought it would be better to set screws about 1/8 to 1/4 below surface to allow for wood shrinkage my fault, as i encourage thinking .
i am bitting the bullet and finally sanding my deck. my main problem is do i fill the nail holes with wood filler. the deck has no roof so get's hit with a lot of rain and sun. i'm worried that the wood filler plug's will pop out over time and/or just won't look good. what is the best way to do it. wood filler or no filler.
screw hole composite deck filler. home > review > wpc products. what should be used to fill the screw holes on a deck? ehow for plastic or composite decking, use an epoxy filler to fill screw holes. mix the epoxy with thinner and use a syringe to fill the holes.
note: if youre trying to fill in nail or screw holes in drywall, use spackling compound or drywall mud rather than wood filler. the technique for filling holes in drywall is very similar to filling holes in wood. heres a great blog post about how to fix nail holes in wood.
fill larger holes with a screw in a color matching the deck surface. or drill a hole ¼ inch wide and about ½ inch deep and cut a ¼-inch dowel to fit in it. 'how to repair nail holes in a
in these cases, just filling a hole in a wood deck wont solve the underlying weakness of the board, and it will be prone to cracking with time. alternatively, you can cut a piece of decking to match the hole, screw it in place, fill in the gaps with wood filler as above, and then re-stain the deck. holes from bugs, rot or fungus
i installed ultra deck on my front porch. it's a nice composite type decking and overall i am satisfied with it. the color will fade, but i was told upfront to expect such. the deck boards are